/diy/ - Do It Yourself

>>1835802
Yea a while back I posted this pic here, and I asked about it but there wasn't any response of it being a problem,

anyways on the adapter print my retraction settings are
>retraction distance - 6.5mm
>retraction speed - 55mm/s

I never messed with my flow rate, and its at 100%, I don't print often because I tend to get too many imperfections, and I just lose motivation to tweak out my printer to remedy the imperfections, so in the world of 3d printing, im still a noob.

The gaps in my prints here between the lines, what could be causing this? I just leveled my bed a week ago, is my nozzile too far away from the print bed?

I was printing at .2mm height @ 20% infill on a ender 3.